Harley Davidson Five Speed Transmissions Hydraulic Clutch Modification
download Hydraulic Clutch Modification for Harley Davidson With Champion Reverse Gear 1 1.1 Install Reverse Gear Assembly to gearbox. 1.2 Remove clutch cover (left side). 1.3 Remove Release Plate...
View ArticleS&S Connecting Rods Installation Instructions
download 1. Female rod crankpin end to mainshaft nuts – .030″ minimum clearance recommended. A. Install sprocket shaft and crankpin in driveside flywheel. Snug nuts only. Do not torque to final specs....
View ArticleDaytona 675, Street Triple Street Triple R Fitting Instruction
download remove the original gear selector rod from the motorcycle. Note: The ball joint and locknut on the transmission linkage have a left hand thread. This is identified by either a machined ring...
View ArticleKAWASAKI 400 PRAIRIE ATV WINCH MOUNT INSTALLATION ISTRUCTIONS
download 1. Place the mounting plate into position on the front bumper tube assembly and attach with the four ¼- 20 u-bolts, hex nuts, and lock washers. See the illustration below for detail. 2. Place...
View ArticleSUSPENSION SERVICE TOOLS/ FORK DAMPER ROD BLEED TOOL
download 33 SHOP EQUIPMENT & TOOLS SUSPENSION SERVICE TOOLS K&L FORK TUBE U-BLOCKS Precision machined from billet aluminum, these quality three piece sets are a handy, accurate and safe way to...
View ArticleTRIUMPH ROCKET III HEEL / TOE SHIFTER INSTALLATION INSTRUCTIONS
download 1. Loosen the 10mm nuts at the ends of the shifter linkage rod (notice one end is a left hand thread). Remove the 10mm nut from the shifter arm & disengage the linkage. Remove the shifter...
View ArticleHARLEY DAVIDSON SPORTSTER ALUMINUM SHIFT LINKAGE KITS INSTALLATION MANUAL
download INSTALLATION 1. See Figure 1. Remove stock capscrews (4) and stock shifter rod (2). Discard stock capscrews. 2. See Figure 2 and Table 2. Loosen the lock nuts (5) and turn the rod ends on the...
View ArticleV-Star 1100 Floorboard/ Foot peg Extension Kit Installation Manual
download 1. Take notice of the position of the shift peg positions relative to the floorboard or foot-peg. You will be adjusting it back to these locations upon installation of the extended linkage. 2....
View ArticleYamaha V-Star 1100 Custom and Classic cruisers Floorboard/ Footpeg Extension...
download Start on the right (brake) side. 1) Loosen the nut at the end of the brake rod. This will allow you to unscrew the brake rod from the brake lever clevis later. 2) Pull out the cotter pin and...
View ArticleHARLEY DAVIDSON ALUMINUM SHIFTER LINKAGE REMOVAL AND INSTALLATION MANUAL
download REMOVAL 1. See Figure 1. Remove stock shifter rod (D). 2. Adjust new shifter rod in kit to match the length of the removed shifter rod by loosening locknuts (3), adjusting the length of the...
View Article
